diff options
Diffstat (limited to 'manual/manual.aux')
| -rw-r--r-- | manual/manual.aux | 23 |
1 files changed, 23 insertions, 0 deletions
diff --git a/manual/manual.aux b/manual/manual.aux new file mode 100644 index 0000000..8a742ab --- /dev/null +++ b/manual/manual.aux @@ -0,0 +1,23 @@ +\relax +\providecommand\hyper@newdestlabel[2]{} +\providecommand\HyperFirstAtBeginDocument{\AtBeginDocument} +\HyperFirstAtBeginDocument{\ifx\hyper@anchor\@undefined +\global\let\oldcontentsline\contentsline +\gdef\contentsline#1#2#3#4{\oldcontentsline{#1}{#2}{#3}} +\global\let\oldnewlabel\newlabel +\gdef\newlabel#1#2{\newlabelxx{#1}#2} +\gdef\newlabelxx#1#2#3#4#5#6{\oldnewlabel{#1}{{#2}{#3}}} +\AtEndDocument{\ifx\hyper@anchor\@undefined +\let\contentsline\oldcontentsline +\let\newlabel\oldnewlabel +\fi} +\fi} +\global\let\hyper@last\relax +\gdef\HyperFirstAtBeginDocument#1{#1} +\providecommand\HyField@AuxAddToFields[1]{} +\providecommand\HyField@AuxAddToCoFields[2]{} +\@writefile{toc}{\contentsline {section}{\numberline {1}Overview \& Performance}{2}{section.1}} +\@writefile{lof}{\contentsline {figure}{\numberline {1}{\ignorespaces Measured current versus set current. On this log-log plot, the entire set-point range of 10 $\mu $A to 9.99 mA can clearly be seen. For both outputs, agreement within measurement error is achieved from 0.30 mA to 9.99 mA. Unfortunately, both outputs become nonlinear at the lowest setpoints, systematically overshooting the desired current. For an unknown reason, the agreement is worse for the left-hand output. All readings were taken with a load of 100 $\Omega $. }}{3}{figure.1}} +\newlabel{fig:setpoint}{{1}{3}{Measured current versus set current. On this log-log plot, the entire set-point range of 10 $\mu $A to 9.99 mA can clearly be seen. For both outputs, agreement within measurement error is achieved from 0.30 mA to 9.99 mA. Unfortunately, both outputs become nonlinear at the lowest setpoints, systematically overshooting the desired current. For an unknown reason, the agreement is worse for the left-hand output. All readings were taken with a load of 100 $\Omega $}{figure.1}{}} +\@writefile{toc}{\contentsline {section}{\numberline {2}Troubleshooting \& Repair}{4}{section.2}} +\@writefile{toc}{\contentsline {section}{\numberline {3}Appendix}{5}{section.3}} |