From 798bd484137439bf1d0752ddde82bf49da4af6b7 Mon Sep 17 00:00:00 2001 From: Blaise Thompson Date: Mon, 16 Apr 2018 13:32:20 -0500 Subject: 2018-04-16 13:32 --- opa/chapter.tex | 9 +++++---- 1 file changed, 5 insertions(+), 4 deletions(-) (limited to 'opa') diff --git a/opa/chapter.tex b/opa/chapter.tex index db88304..00e3203 100644 --- a/opa/chapter.tex +++ b/opa/chapter.tex @@ -121,7 +121,7 @@ After the poweramp, the output signal and idler can be sent through appropriate optionally, mixed further in three subsequent mixing stages to create all of the ranges seen in \autoref{opa:fig:ranges}. % Each of these mixing stages has only crystal angle tunability. % -I describe my strategy for mixer tuning in \autoref{opa:sec:mixer}. % +I describe my strategy for mixer tuning in \autoref{opa:sec:mixers}. % It is important to realize that the total conversion efficiency for each output color varies wildly over all of the different mixing strategies. % @@ -180,7 +180,8 @@ I then search along that contour in \emph{intensity} space to find the motor pos maximum intensity for that color. % Finally I fit a smooth spline through those chosen values to generate the output curve. % -A representative preamp tune procedure output image is shown in \autoref{fig:autotune_preamp}. % +A representative preamp tune procedure output image is shown in +\autoref{opa:fig:autotune_preamp}. % This is an automatically generated image from PyCMDS. % The thick black line is the final output curve. % The dark grey lines are the contours of constant color. % @@ -233,14 +234,14 @@ dimensions (this is especially true at the edge output colors). % In the poweramp, the increased dimensionaity makes it too expensive to do a full multidimensional tuning procedure. % Instead we emply an iterative procedure as diagrammed below. % -\autoref{fig:opa:poweramp_flowchart} diagrams this iterative procedure. % +\autoref{opa:fig:poweramp_flowchart} diagrams this iterative procedure. % We always end the iteration(s) with C2 so that the OPA's color calibration is as good as possible. % Typically only one iteration is required but multiple iterations may be necessary if dramatic OPA realignment has occurred. % In total, poweramp tuning typically takes less than 1 hour. % -Representative procedure output images for D2 (\autoref{op:fig:d2}) and C2 (\autoref{opa:fig:c2}) +Representative procedure output images for D2 (\autoref{opa:fig:d2}) and C2 (\autoref{opa:fig:c2}) are shown. % For the D2 figure, the lower panel shows the intensity of the data taken. % -- cgit v1.2.3